LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-97 April, 2014
of 128 pages
Auxiliary Font
The Auxiliary Font specifies the font to be used for print data which is to be
different than that specified by the primary Print Font.
Note: The Auxiliary Font setting can not be changed when a print job is in
progress.
1. Press the Up or Down triangle on the Printer Setup menu to move the
selection bar to the Auxiliary Font function.
2. Press Enter, which causes the following Auxiliary Font screen to display:
Figure 6-73. Auxiliary Font screen.
Note:
• Brackets ( [ ] ) around a specific font indicate that it is the Default
Configuration Auxiliary Font.
• An arrow () pointing to a specific Auxiliary Font indicates that it is the
Auxiliary Font assigned to the currently displayed configuration.
To Next Page
Loading...
