LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-98 April, 2014
of 128 pages
3. Press the Up or Down triangle to move the selection bar to the Auxiliary Font
desired.
4. Press Enter to save the font selected.
Note:
Pressing Enter after any Printer Setup function has been executed saves the
function. However, it does not store the function.
When the configuration completes, press Back until the Store Configuration
screen displays, and then follow the procedures for executing the Store
function (see page 6-63).
To Next Page
Loading...
