LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-72 April, 2014
of 128 pages
4. The height can be increased or decreased in 2 different ways:
Enter the new height on the numeric keypad and then press Enter.
or
Move the Up or Down triangle (to increase or decrease the height) and
then press Enter.
Note:
Pressing Enter after any Printer Setup function has been executed saves the
function. However, it does not store the function.
When the configuration completes, press Back until the Store Configuration
screen displays, and then follow the procedures for executing the Store
function (see page 6-63).
To Next Page
Loading...
