SATO LP 100R - Page 233

LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-119 April, 2014
of 128 pages
Note:
 Brackets ( [ ] ) around a specific Reverse Mode indicate that it is the
Default Reverse Mode setting.
 An arrow () pointing to a specific Reverse Mode indicates that it is the
setting assigned to the current configuration.
3. Press the Up or Down triangle to move the selection bar to the Reverse Mode
setting desired.
4. Press Enter to save the Reverse Mode setting selected.
Note:
 Pressing Enter after any Printer Setup function has been executed saves the
function. However, it does not store the function.
 When the configuration completes, press Back until the Store Configuration
screen displays, and then follow the procedures for executing the Store
function (see page 6-63).