LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-76 April, 2014
of 128 pages
3. The number of lines per inch can be increased in 0.1000” increments, from a
minimum of 0.1000” to a maximum of 20.0000”.
4. The number of lines per inch can be increased or decreased in 2 different
ways:
Enter the desired number of lines on the numeric keypad and then press
Enter.
or
Move the Up or Down triangle (to increase or decrease the number of
lines) and then press Enter.
Note:
Pressing Enter after any Printer Setup function has been executed saves the
function. However, it does not store the function.
When the configuration completes, press Back until the Store Configuration screen
displays, and then follow the procedures for executing the Store function (see
page 6-63).
To Next Page
Loading...
