LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-43 April, 2014
of 128 pages
Up-Time – The length of time that power to the printer has been turned on,
expressed as either HH:MM:SS if less than 24 hours, or DDD:HH:MM if more
than 24 hours.
Note: Up-Time cannot be changed. It is, however, negated when power to the
printer is turned off.
Set Time – Allows you to change the System Time to either an earlier or later
time.
Set Time Zone – Allows you to set the GMT (Greenwich Mean Time) to the
applicable GMT Offset Time.
Daylight Saving – Allows the automatic start and discontinuance of Daylight
Savings Time when the System Time is in effect.
Note: The Daylight Saving function does not work in conjunction with GMT
Time.
To Next Page
Loading...
