SATO LP 100R - Page 225

LP 100R Laser Printer Operator's Guide Chapter 6: Supervisory Functions
Rev: 1 Page 6-111 April, 2014
of 128 pages
3. The following page numbers can be selected from the Page Buffer Limit
screen:
 05
 08
 12
 18
 24
 32
Note:
• Brackets ( [ ] ) around a specific Page Buffer Limit indicate that it is the
Default Configuration Page Buffer Limit.
• An arrow () pointing to a specific Page Buffer Limit indicates that it is the
Error Recovery mode assigned to the currently displayed configuration.
4. Press the Up or Down triangle to move the selection bar to the Page Buffer
Limit desired.
5. Press Enter to save the Page Buffer Limit selected.
Note:
 Pressing Enter after any Printer Setup function has been executed saves the
function. However, it does not store the function.
 When the configuration completes, press Back until the Store Configuration
screen displays, and then follow the procedures for executing the Store
function (see page 6-63).