LP 100R Laser Printer Operator's Guide Appendix A: Installing System Software
Rev: 1 Page A-5 April, 2014
of 10 pages
10. Open the front door on the printer.
Note: Opening the front door causes the audible alarm to turn off.
11. Remove the USB Flash Drive from the USB port.
12. Wait while printer reboots and will return to the Online Idle screen.
13. Verify that the software has been correctly loaded by visually verifying that the
software rev. level displayed in the lower right-hand corner of the screen is
correct.
14. File the USB Flash Drive in a safe place.
To Next Page
Loading...
