LP 100R Laser Printer Operator's Guide Appendix A: Installing System Software
Rev: 1 Page A-8 April, 2014
of 10 pages
10. If No is selected, an Upgrade Complete message displays.
If Yes is selected, the firmware is overwritten, followed by the display of the
Upgrade Complete message.
11. When the installation of the upgrade software is complete, an Upgrading
Complete message displays.
12. The audible alarm sounds continuously and the following screen displays:
Figure A-6. System Program – Upgrade completed.
13. Open the front door on the printer.
Note: Opening the front door causes the audible alarm to turn off.
14. Remove the USB Flash Drive from the USB port.
To Next Page
Loading...
