LP 100R Laser Printer Operator's Guide Appendix B: Managing Files
Rev: 1 Page B-14 April, 2014
of 60 pages
7. Press Home.
8. The following screen displays:
Figure B-10. Resetting METO-Logic (system program).
Note: There should be no flash drive in the USB port.
9. Press Enter.
10. When Enter is pressed, a Please Wait… message displays until the Reset
function is complete.
11. When the Reset function is completed, the System Start-up screen displays,
and the printer will be in the Online Idle mode.
To Next Page
Loading...
