LP 100R Laser Printer Operator's Guide Chapter 3: Printer Operation
Rev: 1 Page 3-32 April, 2014
of 32 pages
7. Raise the tractor unit by lifting the tractor unit handle.
8. Press the LOAD switch (F), which advances the stock into the printer, lining it
up in the top-of-form position.
Note: If the swing guide is enabled, pressing the LOAD switch causes the
following screen to display:
Figure 3-20. First Fold Direction.
9. Depending on the direction of the first fold, press In or Out.
10. To change the configuration number displayed, press Recall and see Recall
Configurations starting on page 3-19.
F
To Next Page
Loading...
