Siemens FS20 - Creating Firewall Rules

Commissioning security module (firewall) FN2009
-
A1
Creating firewall rules
23
101 |
188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
7. Enter the two optional ICMP services required as shown in the figure below:
– 'Name': ICMP0, 'Type': Echo Request, 'Code': No code
– 'Name': ICMP1, 'Type': Echo Reply, 'Code': No code
 Optional IP services are created.
8. Confirm input with 'OK'.
 'IP Service Definitions' are created.
23.5 Creating firewall rules
ϖ IP service definitions are created.
ϖ The network addresses are known.
1. Right-click on the module for which you want to create firewall rules.
2. Select 'Properties…'.
 The 'Module Properties' window for the selected module is displayed.