Siemens FS20 - Setting Detector Parameter Sets

A
-
Commissioning standalone 'Station' without PC
Setting detector parameter sets
6
40 | 188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
6.3 Setting detector parameter sets
1. Select 'Topology' > ↑ 'Detection tree' > 'Area' > ↑ 'Section' > 'Zone' > 'Detect.'
in the main menu.
2. Press the 'MoreOptions' softkey.
3. Select 'Execute commands'.
4. Select the corresponding command:
– 'Select PS MANNED'
– 'Select PS UNMANNED'
– 'Select PS'
5. Select the desired ↑ parameter set.
 The following message is displayed: 'Command executed'