Siemens FS20 - Removing a Device Permanently; Replacing a Non-Stationary Device of the same Type

Changing and expanding the interactive detector line
Re
moving a device permanently
20
72 | 188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
20.3 Removing a device permanently
To remove a device from the interactive detector line for good, follow the steps
below:
ϖ You have already commissioned the interactive detector line.
ϖ The line is in ↑ normal operation.
1. Switch the detector line off. Link [➙ 82]
2. Detach the device. Link [➙ 85]
– In the case of ↑ non-stationary devices, detach the base as well.
3. Switch the detector line on. Link [➙ 83]
Removing a device with 'SintesoWorks'
1. Load the configuration from the ↑ 'Station' to the PC. Link [➙ 32]
2. Switch the ↑ detector line off. Link [➙ 82]
3. Detach the device. Link [➙ 85]
– In the case of non-stationary devices, detach the base as well.
4. Remove the physical and logical representation of the device in 'SintesoWorks'.
You will find more information in document 009078. See chapter 'Applicable
documents'.
5. Load the configuration from the PC to the 'Station'. Link [➙ 30]
6. Switch the detector line on. Link [➙ 83]
20.4 Replacing a non-stationary device of the same type
To replace a ↑ non-stationary device on the interactive detector line with one of the
same type, follow the steps below:
ϖ You have already commissioned the interactive detector line.
ϖ The line is in ↑ normal operation.
ϖ The new device has not yet been connected.
1. Switch the test mode on. Link [➙ 89]
2. Replace the device. Link [➙ 74]
3. Test the device. Link [➙ 87]
4. Switch normal operation on. Link [➙ 90]