Siemens FS20 - 13 Merging Two Sites

Merging two 'Sites'
Setting detector parameter sets
13
47 |
188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
13 Merging two 'Sites'
You can merge two ↑ 'Sites' to form one 'Site'.
NOTICE
Merging standalone '
Stations
'
You have to convert standalone 'Stations' to networked ↑ 'Stations' to combine
'Stations' into one ↑ 'Site'. You will find more information in chapter 'Converting a
standalone station to a networked station [➙ 81]'.
Prerequisites
● Both ↑ 'Sites' are part of the same sales channel.
● Both 'Sites' have the same firmware version and ↑ BDV version.
● Both 'Sites' have one network.
● Both 'Sites' combined have at most the allowed number of ↑ 'Stations' for a
'Site'.
● Both 'Sites' combined have at most the allowed number of ↑ SAFEDLINK sub-
nets for a 'Site'.
● Wiring between the two 'Sites' is prepared:
– The 'Ethernet switch (MM) FN2008-A1' is installed in the 'Stations' intended
as ↑ router stations and connected to an optical network (FCnet/LAN).
– Large SAFEDLINK sub-nets are in the original state and not yet divided.
– Ethernet sub-nets are in the original state.
You will find additional information about the individual steps on the specified
pages.
Commissioning
1. Add ↑ 'Site' B to 'Site' A. Link [➙ 48]
2. Initialize all ↑ 'Stations' that have a new address. Link [➙ 28]
3. Load the configuration of all 'Stations' in 'Site' A from the PC to the 'Station'.
Link [➙ 30]
4. Connect the 'Sites' physically to one another. Link [➙ 48]
5. Load the configuration of the merged 'Site' from the 'Station' to the PC.
Link [➙ 32]
6. Adapt the configuration in SintesoWorks. Link [➙ 80]
7. Load the configuration from the PC to the 'Station'. Link [➙ 30]
8. Test the function of the 'Site'. Link [➙ 91]
9. Remedy any errors you notice and load the corrected configuration from the
PC to the 'Station'. Link [➙ 30]