Siemens FS20 - Connect the Mains Cable

Commissioning of control panel with AnalogPLU
S detector line
17
64 | 188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
17 Commissioning of control panel with
AnalogPLUS detector line
Creating the ↑ pre-configuration for AlgoRex data migration
You need a pre-configuration in order to commission an AnalogPLUS detector line.
If you are using the ↑ line card (AnalogPLUS) for AlgoRex data migration, you
must migrate the AlgoRex configuration data for the FS20 fire detection system.
You will find more information about AlgoRex data migration in document 009078.
See chapter 'Applicable documents'.
Prerequisites
● The ↑ 'Station' is installed, but the batteries are not connected yet.
● The cables for the ↑ detector lines and the mains supply have been inserted in
the 'Station', but not yet connected.
● SintesoWorks is installed on the PC.
● The latest firmware is installed on the 'Station'.
● The latest ↑ BDV is installed on the 'Station' or is available on the PC.
You will find additional information about the individual steps on the specified
pages.
1. Create the ↑ pre-configuration of the AnalogPLUS detector line. You will find
information about creating a pre-configuration and about AlgoRex data
migration in document 009078. See chapter 'Applicable documents'.
2. Load the pre-configuration in 'SintesoWorks'.
3. Prepare the ↑ 'Station' for commissioning – without ↑ BDV installation.
Link [➙ 77]
4. Connect the PC to the 'Station'. Link [➙ 27]
5. Load the configuration from the PC to the 'Station'. Link [➙ 30]
6. Test the function of the 'Site'. Link [➙ 91]
7. Remedy any errors you notice and load the corrected configuration from the
PC to the 'Station'. Link [➙ 30]
8. Disconnect the PC from the 'Station'. Link [➙ 27]
9. Perform the completion tasks. Link [➙ 91]