Siemens FS20 - 24 Commissioning Ethernet Switch (Modular) FN2012-A1; Standalone FN2012-A1

Commissioning Ethernet switch (modular) FN2012
-
A1
Standalone FN2012
-
A1
24
103 |
188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
24 Commissioning Ethernet switch (modular)
FN2012-A1
Malfunctions during a partial upgrade
Ethernet switch (modular) FN2012 is not compatible with Ethernet switch (MM)
FN2008 and so may only be used in panels ≥MP6.
See also
1 Updating the FW of Ethernet switch (modular) FN2012-A1
[➙ 154]
24.1 Standalone FN2012-A1
This description is for a standalone FN2012-A1 that is not connected to the station.
You will find information on mounting and installing the FN2012
-
A1 in document
008851. See chapter 'Applicable documents'.
The
FN2012
-
A1 has no IP address in the factory setting.
Commissioning the standalone FN2012-A1
ϖ The FN2012-A1 is not connected to the station.
1. Use the rotary switch to define a pre-configured IP address. Link [➙ 104]
2. Put the web interface into operation. Link [➙ 106]
3. Change the IP address of the FN2012-A1 in accordance with your network
requirements. Link [➙ 107]
4. Configure the redundancy role of the FN2012-A1. Link [➙ 108]
5. Deactivate any local ports on the FN2012-A1 that are not being used in
accordance with your safety requirements. Link [➙ 108]
6. Configure fault monitoring for local ports. Link [➙ 109]