Siemens FS20 - Creating IP Service Definitions

Commissioning security module (firewall) FN2009
-
A1
Creating IP service definitions
23
100 | 188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
Loading the network settings to FN2009-A1
ϖ MAC address is entered.
ϖ IP addresses are entered.
1. Highlight the FN2009-A1 module in the project.
2. Select the 'Transfer > 'To Module' menu.
 The network settings are loaded to FN2009-A1.
 Network settings are entered.
23.4 Creating IP service definitions
NOTICE
Different
↑
BACnet port settings in FN2009
-
A1 and
SintesoWorks
No communication possible
●
Configure the same BACnet port in FN2009
-
A1 and
SintesoWorks
.
1. Open the 'Options' > 'IP Service Definitions' menu.
 The 'IP Service Definitions' window is opened.
2. Select the 'IP Services' tab.
3. Click on 'Add IP Service'.
 One row can be edited for one IP service.
4. Enter the two IP services required as shown in the figure above:
– 'Name': Tool, 'Protocol': udp, 'Source Port': *, 'Target Port': 51000
– 'Name': ↑ BACnet, 'Protocol': udp, 'Source Port': *, 'Target Port': 47808
 Required IP services are created.
5. Select the 'ICMP' tab.
6. Click on 'Add ICMP Service'.
 One row can be edited for one ICMP service.