Siemens FS20 - Loading Automatically Created Configuration to the PC; Adapting Configuration

Detailed commissioning steps
Loading automatically created configuration to the PC
21
80 | 188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
21.6 Loading automatically created configuration to the
PC
The description in this chapter only applies if a
configuration has not yet been
loaded to the 'Station' and if the ↑ BDV was installed at the 'Station' after the
'Station' was started for the first time.
1. Select the 'File' > 'New site' menu item.
 The 'Create new site' window opens.
2. Select the 'Upload from station(s)' option field.
3. Click on 'Next'.
 The 'Create site by uploading from station(s)' and 'Connect' windows are
opened.
4. In the 'Connect' window, select 'Local connection' and then click on 'OK'.
 The configuration is loaded to 'SintesoWorks'.
 The progress is displayed in the 'Create site by uploading from station(s)'
window.
 The 'Site properties' window is opened after loading.
5. Change the entries if required and click on 'OK'.
 The 'New site confirmation' window opens.
6. Click on 'Yes'.
 The 'Site' is opened in SintesoWorks.
21.7 Adapting configuration
Adapt the configuration of the ↑ 'Site' in SintesoWorks, e.g.:
● Changing customer texts
● Setting the properties and the parameter sets
● Changing allocation of 'Zones' and 'Sections'
● Configuring controls
● Configuring the operating and display units
● Configuring the network
You will find information on configuring an
↑
'
Site
' in document
009078
. See
chapter 'Applicable documents'.
See also
1 Applicable documents [➙ 11]