Siemens FS20 - Loading Data to the Station; Initializing Station

Connectivity and communication wit
h 'Station'
Loading data to the 'Station'
4
28 | 188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
4.5 Loading data to the 'Station'
Data is loaded from SintesoWorks to the 'Station' when the following commands
are performed.
● 'Initialize station'
● 'Download site'
If you use a number of network cards on the PC, observe the information in the
chapter 'IP settings for several network cards' in document 009078. See chapter
'Applicable documents'.
The table below shows which data is overwritten in the 'Station'.
Command
Overwrites the
↑ BDV
Sets the address
of the 'Station'
Overwrites the
configuration
'Initialize station'
1
Yes Yes Yes
'Download site' Yes No Yes
2
1
Command is only performed for the 'Station' that is connected to the PC via LAN.
2
The configuration of selected 'Stations' or all 'Stations' in the ↑ 'Site' can be
overwritten as an option.
See also
1 Initializing 'Station' [➙ 28]
1 Loading configuration from the PC to the station [➙ 30]
4.6 Initializing 'Station'
● Each ↑ 'Station' in a system with several networked 'Stations' must have a
unique address.
● Once a 'Station' has been started for the first time or once the firmware on the
main CPU has been updated, a 'Station' has the address '1'. Networked
'Stations' must therefore all be initialized.
● If two 'Sites' are merged to form one ↑ 'Site', the 'Stations' with the same
addresses in the added 'Site' must each be given a new address.
● The 'Initialize station' procedure issues the 'Station' an address within the 'Site'
according to the configuration in SintesoWorks.
A
↑
standalone '
Station
' does not have to be initialized.
If you use a number of network cards on the PC, observe the information in the
chapter 'IP settings for several network cards' in document 009078. See chapter
'Applicable documents'.