Siemens FS20 - Standards and Directives Complied with; CPR Conformity and Firmware Version; Release Notes

Safety
Standards and directives compli
ed with
2
20 | 188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
2.3 Standards and directives complied with
A list of the standards and directives complied with is available from your Siemens
contact.
2.3.1 CPR conformity and firmware version
In order to satisfy Ordinance No. 305/2011 (the Construction Products Regulation –
CPR), the firmware of a newly installed fire detection installation must be current
market package version MP6 or higher.
NOTICE
Firmware version of a newly installed fire detection installation not updated
No CPR conformity
● Compare the firmware version of a newly installed fire detection installation
with the firmware version MP6.
●
Update the firmware if necessary.
2.4 Release Notes
Limitations to the configuration or use of devices in a fire detection installation with
a particular firmware version are possible.
WARNING
Limited or non
-
existent fire detection
Personal injury and damage to property in the event of a fire.
● Read the 'Release Notes' before you plan and/or configure a fire detection
installation.
● Read the 'Release Notes' before you carry out a firmware update to a fire
detection installation.
NOTICE
Incorrect planning and/or configuration
Important standards and specifications are not satisfied.
Fire detection installation is not accepted for commissioning.
Additional expense resulting from necessary new planning and/or configuration.
● Read the 'Release Notes' before you plan and/or configure a fire detection
installation.
● Read the 'Release Notes' before you carry out a firmware update to a fire
detection installation.