Changing and expanding the AnalogPLUS detector line
18
68 | 188
18.9 Readdressing devices
To readdress devices on the AnalogPLUS detector line, follow the steps below:
ϖ You have already commissioned the AnalogPLUS detector line.
ϖ The line is in ↑ normal operation.
1. In the main menu, select 'Topology' > 'Hardware tree' > 'Station' > ↑ Line card
> ↑ Detector line.
2. Press the 'More Options' softkey and select 'Execute commands'.
3. Select the 'Re-address devices' command.
The devices on the detector line are readdressed.
detector line is complete, the process of readdressing the devices in a
↑ loop takes approximately 11 s. If there is a wire break in the loop, device
readdressing may take around 21 s.
18.10 Replacing an AnalogPLUS device
1. Remove the device you want to replace from the base.
2. Wait for 60 seconds max. or 0.5 seconds per device.
3. Insert the new device of the same type.
To Next Page
Loading...
