Siemens FS20 - Converting a Standalone Station to a Networked Station

Detailed commissioning steps
Converting a standalone station to a networked station
21
81 |
188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
21.8 Converting a standalone station to a networked
station
NOTICE
Configuring IP addresses manually
Once a standalone 'Station' has been converted to a networked 'Station', you
have to configure the IP address manually.
ϖ The configuration for an ↑ 'Site' with a standalone 'Station' is loaded to
SintesoWorks.
1. Select the 'Network' task card.
2. Open 'Global system configuration' > 'FS20 network configuration' > 'Ethernet
sub-net' in the tree view.
3. Select 'Connections' to configure an Ethernet network.
– Alternative for SAFEDLINK network: Select 'Ethernet sub-net'.
– Select 'New element'.
– Add the 'SAFEDLINK sub-net' element.
– Open 'SAFEDLINK sub-net'.
– Select 'Connections'.
4. In the menu bar, click on 'Assign'.
 The 'Assign dialog' window opens.
5. Select the 'Network tree' on the right of the 'Station' and click on 'Assign'.
 The standalone 'Station' is now a networked 'Station'.
6. Select the 'Station' under 'Connections'.
7. Configure the IP address on the 'Overview' tab.
 You have converted the standalone 'Station' to a networked 'Station'.