Siemens FS20 - 20 Changing and Expanding the Interactive Detector Line; Adding a Device to the Detector Line; Replacing a Device with One of a Different Type

Changing and expanding the interactive detector line
Adding a device to the detector line
20
71 |
188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
20 Changing and expanding the interactive
detector line
20.1 Adding a device to the detector line
WARNING
No alarm when there is no logical
↑
assignment
If a device is read in on the ↑ 'Station' on the interactive detector line, but is not
assigned to any logical element in the configuration, the device cannot indicate an
alarm. No alarm will be indicated on the line when an alarm is triggered.
To expand an interactive detector line by adding a new device, follow the steps
below:
1. Switch the ↑ detector line off. Link [➙ 82]
2. Mount and wire the new devices. Link [➙ 49], same process as for FDnet
devices.
3. Read in the devices. You will find more information in chapter 'Commissioning
of control panel with interactive detector line [➙ 69]'.
4. Connect the PC to the ↑ 'Station'. Link [➙ 27]
5. Load the configuration from the 'Station' to the PC. Link [➙ 32]
6. Configure the new devices. Link [➙ 50], same process as for FDnet devices.
7. Load the configuration from the PC to the 'Station'. Link [➙ 30]
8. Test the function of the 'Site'. Link [➙ 91]
9. Remedy any errors you notice and load the corrected configuration from the
PC to the 'Station'. Link [➙ 30]
10. Disconnect the PC from the 'Station'. Link [➙ 27]
20.2 Replacing a device with one of a different type
To replace a device on the interactive detector line with one of a different type,
follow the steps below:
1. Remove the device that you want to replace for good. Link [➙ 72]
2. Add the new device to the ↑ detector line. Link [➙ 71]