Siemens FS20 - 28 Commissioning External Printer

Commissioning external printer
28
114 | 188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
28 Commissioning external printer
The external FUJITSU DL3750+ printer can be installed and commissioned using
the operating manual. The operating manual is on the CD delivered with the
printer.
To operate the printer on the fire detection system FS20 settings that differ from
the default values must be made in the following functions.
● 'MENU 1': Assignment of print functions to MENU1 in the printer Person
Machine Interface.
● 'MENU 2': Assignment of print functions to MENU2 in the printer Person
Machine Interface.
● 'HARDWRE': Changing the printer hardware options.
● 'ADJUST': Changing the setting options for the print position.
● 'CONFIG': Changing the configuration options.
The printer must be set to configuration mode in order to do this. You will find
information on this in document A6V10224853. See chapter 'Applicable
documents'. The following table shows the options to be set.
Function Value
MENU 1
EMULATE XL24E
FONT COUR 10
QUALITY LETTER
PITCH 10 CPI
LINE SP 6 LPI
CHAR-W NORMAL
CHAR-H NORMAL
ATTRIB NONE
PAGE LG 12.0 IN
LFT-END 1 COLM
TOP-MRG 1 LINE
LANGUAGE LATIN-9
CHR-SET SET1
AGM OFF
PRF-SKP NO-SKIP
ZEROFNT NO-SLSH
CR-CODE CR ONLY
LF-CODE LF & CR
RGHTEND WRAP
==END==