Updating the FW of the peripheral devices
29
148 | 188
Updating the firmware
Check the COM port setting under '
before performing the firmware update.
1. Select 'Update' > 'Periphery update wizard'.
2. In the 'Password check' window, enter the password '1234' and click on the
'Next' button.
3. Select the 'Standard FDnet device' element in the 'Devices:' field.
The connection with the FDCW221 is established.
4. Set the FDCW221 to update mode manually:
– Disconnect the MC link cable from the MCL-USB adapter.
– Hold the end of the MC link cable against the ground terminal of the ↑ radio
gateway.
– Press the Reset button.
The device is set to update mode.
– Insert the end of the MC link cable in the MCL-USB adapter again.
5. Click on 'Next'.
The latest firmware package and the latest firmware version are suggested.
6. Follow the instructions in the dialog and perform the update.
The FDCW221 restarts.
7. Remove the MCL-USB adapter and lock the FDCW221.
The firmware is updated.
29.8.6 Radio gateway FDCW221
You must update the firmware of the ↑ radio gateway FDCW241 with a SWING
tool and the MCL-USB adapter FDUZ227. You will find information on this in
document A6V10227639. See chapter 'Applicable documents'.
See also
1 Applicable documents [➙ 11]
To Next Page
Loading...
