Adding 'Site' B to 'Site' A
13
48 | 188
13.1 Adding 'Site' B to 'Site' A
ϖ ↑ 'Site' A is open in SintesoWorks.
1. Select 'Edit' > 'Merge sites'.
The 'Merge sites' wizard opens.
2. Enter the path and name of 'Site' B that you would like to merge with 'Site' A.
3. Enter the path and name of the new merged 'Merged site:' in field 'Site'.
4. Click on 'Next'.
The conditions for merging are checked.
The results of the check are listed in the 'Merge sites pre-check.' window.
5. Click on 'Next' if 'Result' is everywhere in the 'ok' column.
– If 'ok' is not everywhere, click on 'Cancel' and ensure that all the conditions
that are listed in the 'Check' column are satisfied.
SintesoWorks checks whether there are address conflicts at 'Stations'
levels and suggests a possible new address.
The possible new address is listed in the 'Station re-addressing.' window.
6. Check the suggested addresses for the 'Stations' in 'Site' B and adapt them if
necessary. The 'New address' column can be edited.
7. Check the 'Reconfigure network' checkbox if you want to reset the existing
network configurations for the original 'Sites'. All network configuration values
are then reset to the standard values.
8. Click on 'Finish'.
The 'Sites' are merged.
The 'Merge completed.' window opens.
9. The 'Required action' column informs you which action needs to be carried out
for the 'Stations':
– 'INITIALIZE': The 'Station' must be initialized
– 'DOWNLOAD': Loading the configuration from the PC to the 'Site' will
suffice
10. Click on 'Show the log file.' to view the protocol.
11. Click on 'Save report as file...' to save and print a merging report. This report
also shows which 'Stations' must be initialized.
12. Click on the 'OK' button to close the window.
13.2 Connecting 'Sites' physically to one another
Connect the two 'Sites' physically to one another.
You will find more information in document 008851. See chapter 'Applicable
documents'.
See also
1 Applicable documents [➙ 11]
To Next Page
Loading...
