Siemens FS20 - Network Parameters

Connectivity and communication with 'Station'
Network parameters
4
26 | 188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
5. Set the following values:
– 'Protocol type': 'UDP'
– 'Local port': 'Specific Ports', and enter the value range '50067-50070' in the
box.
– 'Remote port': 'All Ports'
6. Confirm with 'OK'.
 The new firewall rule is now configured.
NOTICE
Security vulnerability in operating system due to open ports
Unauthorized access to your PC
●
Deactivate the firewall rule configured above after the firmware update.
4.2 Network parameters
Ports in FS20
Use Port number
Transport
protocol
Application
protocol
Comment
Communication
Station-to-station
communication
50501 UDP FCnet
Communication between
Engineering Tool and
station
51000 UDP FCnet
Communication between
management station and
FS20 station
47808-47823 UDP BACnet ● Dependent on configuration
● Between BAC0 and BACF by
default
Monitoring
Station to station 50502 UDP FCnet
Remote access via cRSP
Between Engineering Tool
and station
51001-51250 UDP FCnet ● Dependent on configuration
● Rule for ports: portHost =
51000 + hostID
Firmware update
Engineering tool 50067 UDP FW update
Panel 50068 UDP FW update
Engineering tool 50069 UDP FW update
Engineering tool 50070 UDP FW update