Siemens FS20 - Delete the Device on Person Machine Interface; Remove the Elements

Detailed commissioning steps
Delete the device
on Person Machine Interface
21
86 | 188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
21.16 Delete the device on Person Machine Interface
1. Mark the corresponding device fault message.
2. Press the 'More Options' softkey.
3. Select the 'Show topology' menu item.
 The logical channel is displayed. For some devices, 'Device' is displayed
directly.
4. Press the 'More Options' softkey.
5. Select the 'Jump to link' menu item.
 The physical channel is displayed.
6. Press the 'Upper level' softkey.
 'Device' is displayed.
7. Press the 'More Options' softkey.
8. Select the 'Execute commands' menu item.
9. Select the 'Remove/delete device' command.
 The control panel deletes the physical representation of the removed device.
 The logical channel element remains in the 'Zone'.
21.17 Remove the elements
If you have uninstalled an FDnet device for good, the corresponding elements, e.g.
the 'SintesoWorks' must be removed from the logical structure trees in Zone. You
can search for elements using the 'Find' function.
You will find more information in document 009078. See chapter 'Applicable
documents'.
See also
1 Applicable documents [➙ 11]