Siemens FS20 - Read in Devices on Detector Line; Detaching the Device

Detailed commissioning steps
Read in devices on detector line
21
85 |
188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
21.14 Read in devices on detector line
NOTICE
Incorrect order for reading in a
↑
loop
Error when reading in a loop.
The FDnet detector lines are detected as ↑ stubs during the first system startup,
e.g., 'Line' 11, 'Line' 12 (2-digit line number), even if they are connected as a loop.
● For loop with line separator: Switch the second 'Line' / 'Line' 12 off.
● To read in a loop, always select the first 'Line', in this case 'Line' 11. 'Line' 12
is then read in automatically.
A loop is displayed with a 1-digit line number, in this case as 'Line' 1 once it
has been read in.
●
Proceed in the same way from '
Line
'
21/22 (loop 2) to '
Line
'
41/42 (loop 4).
ϖ For ↑ loop with line separator: The second 'Line' is switched off. Link [➙ 82]
1. In the main menu, select 'Topology' > 'Hardware tree' > ↑ 'Station' > ↑ Line
card > ↑ Detector line.
2. Press the 'More Options' softkey and select 'Execute commands'.
3. Select the 'Read in installed devices' command.
 The FDnet devices are read in.
 The following message is shown following successful reading in:
'Command executed'
21.15 Detaching the device
If you want to permanently remove a device, uninstall the device and, if required,
the base and connect the wires of the ↑ detector line.
You will find more information about installing and uninstalling in the
documentation for the corresponding device.