Siemens FS20 - MCL-USB Adapter Fduz22 X

Updating the firmware
Updating the FW of the peripheral devices
29
139 |
188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
29.8.1 MCL-USB adapter FDUZ22x
The firmware of the MCL-USB adapter FDUZ221 or the MCL-USB adapter (radio)
FDUZ227 must be updated if a new firmware version is issued.
Preparation
ϖ The driver for the MCL-USB adapter is installed on the PC.
1. Select 'File' > 'Import new resource package'.
2. In the selection window open the corresponding file F-FXS2007-XX_x_x_...zip.
3. Connect the MCL-USB adapter to the PC.
 The orange LED on the MCL-USB adapter flashes for a short while. When the
device is ready for operation, the green LED lights up.
Figure 7: Connection of the PC to the MCL-USB adapter
Updating the firmware
Check the COM port setting under '
Options
' > '
Preferences
' > '
Periphery update
'
before performing the firmware update.
1. Select 'Update' > 'Periphery update wizard'.
2. In the 'Password check' window, enter the password '1234' and click on the
'Next' button.
3. Select the FDUZ22x in the 'Devices:' field.
 The connection with the FDUZ22x is established.
 The latest firmware package and the latest firmware version are suggested.
4. Click on 'Next'.
5. Follow the instructions in the dialog and perform the update.
 The FDUZ22x restarts.
 When the device is ready for operation, the green LED on the FDUZ22x
lights up.
6. Disconnect the FDUZ22x from the PC.
 The firmware is updated.
FDUZ221/FDUZ227
USB