Siemens FS20 - Router Station and Ethernet Station; Converting the Configuration

Updating the firmware
Converting the configuration
29
136 | 188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
29.4.2 Router station and Ethernet station
You will find additional information about the individual steps on the specified
pages.
ϖ Familiarize yourself with the information in 'Preparation and security [➙ 117]'.
1. Import the new ↑ BDV into SintesoWorks.
– Select the 'File' > 'Import new BDV' menu item and open the file you want.
2. Load the configuration from the 'Station' or your archive to the PC. Link [➙ 32]
3. Convert the configuration and rectify conversion faults. Link [➙ 136]
4. Remove the network connection to the 'Station' and connect the PC.
Link [➙ 27]
5. Enable the 'Station'.
– Press <MENU> and enter a valid PIN.
6. Load the converted configuration from the PC to the 'Station'. Link [➙ 30]
7. Disconnect the PC from the 'Station'. Link [➙ 27]
8. Restore the network connection.
29.5 Converting the configuration
You will find detailed information on converting ↑ 'Sites' in document
A6V10244961. See chapter 'Applicable documents'.
Converting the configuration
ϖ The ↑ 'Site' you want to convert is saved and loaded in SintesoWorks.
1. Select the 'Edit' > 'Convert site' menu item.
 The following window is opened:
2. Select the ↑ BDV you want and click on 'Convert'.
 The 'Action confirmation' window opens.
3. Click on 'Yes'.
 The 'Site' is converted.