Changing and expanding the AnalogPLUS detector line
Adding a device to the detector line
18
65 |
Building Technologies
18 Changing and expanding the AnalogPLUS
detector line
18.1 Adding a device to the detector line
NOTICE
to detect device when it is read in
An AnalogPLUS detector line cannot be expanded by reading a device in on the
↑ 'Station', as the system is unable to identify the device.
WARNING
alarm when a device has been read in
Devices on the AnalogPLUS detector line cannot be read in on the ↑ 'Station'. No
alarm will be indicated on the line when an alarm is triggered.
extension of the line, all possible wiring work on the bases must be
carried out from devices that have already been localized. When replacing these
devices, they must be re-inserted in exactly the same place.
To expand an AnalogPLUS detector line by adding a new device, follow the steps
below:
ϖ You have already commissioned the AnalogPLUS detector line including the
↑ pre-configuration. Link [➙ 64]
1. Adapt the ↑ detector line configuration in 'SintesoWorks'.
– Insert the new device in the configuration.
– If the device is inserted between devices that have already been
commissioned, the existing addresses must be adjusted by selecting 'Edit'
> 'Change element address: +1'.
2. Install the device on the detector line in accordance with the pre-configuration.
– Remove these devices from their bases.
– Mount and wire the new devices, like bases.
– Insert the new devices into the new bases.
3. Put the AnalogPLUS detector line into operation. Link [➙ 64], from point 4 on.
18.2 Replacing a device with one of a different type
To replace a device on the AnalogPLUS detector line with one of a different type,
follow the steps below:
1. Remove the device that you want to replace for good. Link [➙ 66]
2. Add the new device to the ↑ detector line. Link [➙ 65]
To Next Page
Loading...
