Siemens FS20 - Page 99

Commissioning security module (firewal
l) FN2009
-
A1
Entering network settings
23
99 |
188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
2. Select the 'Routing Mode' tab.
 The following entry mask is displayed:
3. Check the 'Routing active' checkbox.
4. Enter the following 'internal module IP address': 192.168.201.2.
5. Confirm input with 'OK'.
 'Internal sub-net mask' is automatically created.
 'Routing Mode' is active.
Entering router network data, 'Router'
The
following settings apply for the planned network access to GAP with activated
DHCP server.
1. Open the 'Module Properties' window again.
 The 'Network' tab is displayed.
2. Click on 'Add Router'.
 The 'Sub-net Mask' '255.255.255.0' is already entered.
3. Correct the 'Sub-net Mask' from '255.255.255.0' to '255.255.0.0'.
4. Enter the following network data:
– 'Router IP': 192.168.201.1
– 'Network ID': 192.168.0.0
5. Confirm input with 'OK'.
 The router network data is entered.