Siemens FS20 - Page 146

Updating the
firmware
Updating the FW of the peripheral devices
29
146 | 188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
Manually setting device to update mode
Proceed as follows if you are prompted to manually set the device to update mode
in step 3:
1. Set the DIP switch S200-1 to 'ON'.
 The device is set to update mode.
2. Follow the instructions in the dialog in the Engineering Tool.
3. Set the DIP switch S200-1 to 'OFF'.
4. Follow the additional instructions in the dialog in the Engineering Tool.
FT2001-A1 Printed circuit board view
S200
1
1
1
1
1
1
12
ON