Siemens FS20 - Page 33

Connectivity and communication with 'Station'
Creating a backup of the 'Site' configuration
4
33 |
188
Building Technologies
009052_s_en_
--
Fire Safety
2016
-
06
-
02
Creating a backup
ϖ The ↑ 'Site' is opened in SintesoWorks.
ϖ The PC is connected to a ↑ 'Station'.
1. Select 'Commissioning' > 'Create backup embedded configuration'.
 The 'Create backup embedded configuration' And 'Connect' windows are
opened.
2. Select the connection in the 'Connect' window and click on 'OK'.
 The 'Site' configuration is loaded to the PC and saved as a backup file.
 The progress is displayed in the 'Create backup embedded configuration'
window.
Backup file
● The backup file is saved in the following directory as standard:
C:\ProgramData\Siemens\FX2030\[Softwareversion]\Sites\embeddedBackups
● The backup file has the following name:
<'Site' name>_<backup counter>(_incomplete).fsc
Example: Test_Site_007_incomplete.fsc
– 'Site' name: Name of the 'Site'.
– Backup counter: Three-digit number that is automatically assigned to each
backup.
– 'incomplete': If it was not possible to create a complete backup, 'incomplete'
is added to the file name.
● A maximum of ten 'Site' backup files are saved. If more than ten backup files
are created, the oldest file is automatically overwritten with the new one.
In the pre
-
settings, you can define that a backup file is created automatically each
time a configuration is loaded from the PC to the ↑ 'Station' using the 'Download
site' command. To do this, select 'Options' > 'Preferences' > 'Commissioning'.