Sirona Sinius - Page 211

63 22 726 D3561
D3561.201.01.03.02 05.2012
211
Sirona Dental Systems GmbH 5 Care, cleaning and maintenance by the practice team
Operating Instructions SINIUS / SINIUS CS 5.6 Sanitation
båÖäáëÜ
 The receptacle for the water-carrying instruments and suction
hoses are completely assembled.
5. Touch the
Start key on the touchscreen.
Sanitation phase 2 – Checking the water flow
First the treatment center checks whether there is water flow through the
instruments.
✔ Sanitation phase 2 is highlighted on the touchscreen.
➢ Wait briefly until the water flow has been checked.
 If sufficient water flow is present, the treatment center continues
with sanitation phase 3.
Error message: No water flow
If the treatment center detects no water flow through an instrument or
through the tumbler filler, you can try to restore water flow at the location
concerned. If this is not possible, the instrument concerned can be
excluded from the sanitation process.
1. Check the water flow through the instruments in the instrument
positions marked with a warning triangle on the touchscreen. Set to
maximum water flow on the instruments. Leave all instruments
plugged into the water unit.
 If the treatment center detects the water flow, the warning triangle
will disappear. If there is sufficient water flow through all
instruments, sanitation phase 3 automatically continues.
2. If you want to exclude the instruments concerned from sanitation,
touch the
Exclude instrument key.
 The treatment center then continues with sanitation phase 3. The
water lines you excluded are not included in the sanitation
process.
If it is impossible to restore the flow to the tumbler filling unit, sanitation is
not possible. The tumbler filling unit cannot be excluded from the
sanitation process.
IMPORTANT
Pinching of the instrument hoses
Be careful not to pinch the instrument hoses when inserting the
instruments.
If the hoses are pinched, the water flow will be obstructed during
purging.