Sirona Sinius - Page 226

63 22 726 D3561
226 D3561.201.01.03.02 05.2012
10 Overview of all function keys Sirona Dental Systems GmbH
10.1 Fixed keys Operating Instructions SINIUS / SINIUS CS
Composite function
Switches the composite setting for the operating light on/off.
This function is required to prevent the premature curing of composite
fillings.
Reduced light intensity < 8,000 lux
Tumbler filling
Starts or stops the tumbler filling function.
When the
Tumbler filling key is pressed (> 2 s), the filling time and water
heating settings screen appears.
Flushing
Starts or stops the flushing of the cuspidor bowl.
When the
Flushing key is pressed (> 2 s), the Flushing Time settings
screen appears.
Freely selectable function
e.g. call key
Freely available relay 230 VAC, 6 A
(connected by the service engineer).
This function can be preset as a button or as a switch in the Setup
program.
Freely selectable function
Freely available relay 230 VAC, 6 A
(connected by the service engineer).
This function can be preset as a button or as a switch in the Setup
program.
Clean key
Pressing this key deactivates the complete user interface of the dentist
element. Pressing it again > 2 s reactivates the control panel.
This is used to make sure that no unwanted functions can be accidentally
triggered while cleaning the surface.
Setup key
Used for individual configuration of the treatment center by the user and
for reading out messages by the service engineer, see "Configuration of
the treatment center (Setup)" [ → 157].