Thermo Scientific Applied Biosystems QuantStudio 7 Pro - Create a new local instrument profile; Link a local profile to a Connect profile

5.
(Optional) Tap the Confirm PIN field, enter the four-digit numerical PIN again, then tap Enter.
6.
Tap Done.
Create a new local instrument profile
A local instrument profile is not compatible with Connect-enabled features. A local instrument profile
can be linked to Connect at a later time.
To link a local instrument profile to Connect at a later time, see “Link a local profile to a Connect profile”
on page 127.
For a description of linking a local instrument profile to Connect, see “If you link when you are signed in
to the instrument” on page 129.
1.
In the Sign In screen, tap Get Started.
2.
Tap Create Profile.
3.
Tap the User name field, enter a user name, then tap Enter.
4.
Tap the PIN (4 digits required) field, enter a four-digit numerical PIN, then tap Enter.
Tap the Show PIN checkbox to show or hide the PIN.
5.
Tap the Confirm PIN field, enter the four-digit numerical PIN again, then tap Enter.
6.
Tap Create Profile.
Proceed immediately to set up facial authentication (see “Set up facial authentication at the initial
creation of an instrument profile” on page 131) or tap Skip to set up facial authentication at a later time.
Link a local profile to a Connect profile
This section describes linking a local instrument profile to a Connect profile, if a local instrument profile
was created first.
The first time you use your Connect account on an instrument, you will be prompted to create a four-
digit numerical PIN. This PIN is to use when signing in to the instrument with your Connect account.
It will apply to all other instruments when you use your Connect account. This does not change the
password when signing in to your Connect account on a browser.
After the PIN is set up on the instrument, it must be changed with your Connect account on a browser
(see “Change the PIN for a Connect profile” on page 133).
The first time the instrument is used with a Connect account, a region must be selected.
For a detailed description of the profile, see “If you link when you are signed in to the instrument” on
page 129.
Chapter 8 Manage pr
ofiles
Create a new local instrument profile
8
QuantStudio
™
6 Pro Real-Time PCR System and QuantStudio
™
7 Pro Real-Time PCR System User Guide
127