2.
Tap Privacy.
The privacy policy is displayed.
3.
Tap Close.
Configure the instrument settings
Enable or disable demonstration mode
Note: The instrument r
estarts when demonstration mode is turned on or o.
When the instrument is in demonstration mode, the following features apply:
•
The instrument simulat
es a run but does not start a run.
•
The instrument drawer will not open.
1.
In the home screen, tap
(Settings)4Instrument settings4Demo mode.
T
urn demo mode o is displayed if the instrument is in demo mode.
2.
In the Confirmation screen, tap Ok.
You will be prompted to restart the instrument.
Demo mode is displayed on the instrument when it is in demonstration mode.
Edit the instrument name (administrator only)
1.
In the home scr
een, tap
(Settings)4Instrument settings4Instrument name.
2.
T
ap the Instrument name field, then enter or edit the instrument name.
The instrument name must be unique if it is connected to a network.
3.
Tap Done.
Set the date and the time
The date and time can be set manually or automatically. The instrument must be connected to the
int
ernet to set the date and time automatically.
1.
In the home screen, tap (Settings)4Instrument settings4Date and time.
The Date and Time screen is displayed.
2.
Set the slider to O or On to determine if the date and time are set automatically.
3.
(Optional) Select the time zone from the dropdown list.
4.
Select the date format and the time format from the dropdown lists.
5.
Tap Done.
Chapter 11 Configur
e the instrument settings
Configure the instrument settings
11
168
QuantStudio
™
6 Pro Real-Time PCR System and QuantStudio
™
7 Pro Real-Time PCR System User Guide
To Next Page
Loading...
