Thermo Scientific Applied Biosystems QuantStudio 7 Pro - Connect the instrument to a wired network

6.
Set the Internet Protocol (TCP/IP) Properties for either DHCP or Static IP communication:
Network configuration Action
DHCP
1.
Select Obtain an IP address automatically.
2.
Set the DNS address. If the computer obtains DNS addresses:
•
Automatically – Select Obtain DNS server address automatically.
•
Statically – Select Use the following DNS address, then enter the
address of the preferred and alternate DNS servers (if available).
Static IP
1.
Select Use the following IP address.
2.
In the IP Address field, enter the static IP address.
3.
If necessary, enter a subnet mask.
4.
If necessary, enter a static gateway address in the Default Gateway
field.
7.
If your network r
equires advanced TCP/IP setup (such as WINS), define the settings:
a.
Click Advanced in the Internet Protocol (TCP/IP) Properties dialog box.
b.
Define the IP Settings, DNS, and WINS tabs as instructed by your systems administrator, then
click OK.
8.
Close all dialog boxes by clicking OK, then re-start the computer.
The computer is now visible to other computers on the network.
Connect the instrument to a wired network
1.
In the home screen, tap
(Settings)4Instrument settings4Network configur
ation.
The Network Connections screen is displayed.
2.
Tap Edit.
3.
Tap one of the active fields found under the Wired option.
4.
Select a wired network connection:
Wired network connection Action
DHCP No further action is required.
Static IP
1.
In the IP Addr
ess field, enter the static IP address.
2.
If necessary, enter a subnet mask.
3.
If necessary, enter a static gateway address in the Default
Gateway field.
Appendix B Connect the instrument to a network
Connect the instrument to a wired network
B
194
QuantStudio
™
6 Pro Real-Time PCR System and QuantStudio
™
7 Pro Real-Time PCR System User Guide