Thermo Scientific Applied Biosystems QuantStudio 7 Pro - Power on the instrument; Power off the instrument

Power on the instrument
If left unattended, the instrument automatically enters sleep mode to conserve power. The default time
that an instrument is inactive before going into sleep mode is 15 minutes.
1.
Tap anywhere on the touchscreen to determine if the instrument is in sleep mode.
If the screen becomes active, the instrument is already powered on.
2.
If the home screen does not display, power on the instrument by pressing the ON/OFF switch on
the rear panel.
1
Figure 24 Location of the ON/OFF switch
1
ON/OFF switch
Note: The length of time that the instrument is inactive befor
e going into sleep mode can be
customized (see “Enable and edit sleep mode” on page 163).
Power o the instrument
1.
P
ower o the instrument using the ON/OFF switch on the back of the instrument.
For the location of the ON/OFF switch, see Figure 6 on page 43.
2.
Power o the computer if there is a computer directly connected to the instrument.
Chapter 10 Maintain the instrument
P
ower on or o, store, and move
10
164
QuantStudio
™
6 Pro Real-Time PCR System and QuantStudio
™
7 Pro Real-Time PCR System User Guide