EN
110
Software Module
11.8.3.3. Value
Objective
The brightness filter can be adjusted.
Property
The following settings/results appear.
Active The brightness filter can be activated or deactivated.
Threshold Low Sets the lower threshold for brightness.
Threshold High Sets the upper threshold for brightness.
11.8.3.4. Saturation
Objective
The saturation filter can be adjusted.
Property
The following settings/results appear.
Active The saturation filter can be activated or deactivated.
Threshold Low Sets the lower threshold for saturation.
Threshold High Sets the upper threshold for saturation.
11.9. Module Cluster
11.9.1. Overview
Objective
Detect, count or sort objects reliably in order to check for presence and correct quan-
tity.
Prerequisites
1. Sensor is correctly connected (see section 5.5)
2. Connection has been established from the sensor to the software (see section
10.1.1)
3. The camera is configured / images are selected (see section 11.2)
4. If applicable, tracking is configured (see sections 11.3 and 11.4)
5. Region of interest is specified (see section 11.5)
6. If applicable, a filter is activated (see section 11.6)
Procedure
The minimum and maximum number of neighboring pixels which make up a cluster
need to be specified. It’s also possible to specify the maximum number of objects to be
counted, as well as the criteria according to which the objects will be sorted.
To Next Page
Loading...