Wenglor B50 - Display; Intensity

25
Smart Camera / Vision-Sensor / 1D-/2D-Code-Scanner / OCR Reader
6.4. Display
Various changes can be made to the settings at the display in order to simplify operation of the sensor.
Display
Display settings
Rotate
Intensity
Mode
 Back
 Run
Rotate: Rotate the display 180°. The display is rotated 180° by pressing
the 8 key. The display can be returned to its original position by
pressing the same key once again.
Intensity: Adjust display intensity.
Mode: Selection of various display modes for the “Run” mode
6.4.1. Intensity
Display intensity can be adjusted, for example to assure that the display is still easily legible even in bright
environments.
Display
Adjusting display intensity
O Minimum
O Normal
O Maximum
O Energy saving
O Screensaver
 Back
 Run
Minimum: Display intensity is set to the smallest possible value.
Normal: Display intensity is set to the middle value.
Maximum: Display intensity is set to the highest possible value.
Energy saving: If no keys are pressed for a period of one minute, the display is
switched off, and is switched back on as soon as a key is acti-
vated.
Screensaver: If no keys are pressed for a period of 30 seconds, the display is
switched to the display mode and returns to the last used menu as
soon as a key is activated.