EN
28
Functions Description, OLED Display
Exiting the assistant
You have com-
pleted all of the
steps offered by
the assistant.
Do you want to
run the assistant
again?
Y
If you want to run the assistant again, press the “Y” key.
After pressing the “N” key, the assistant is exited and the display is switched to the
display mode.
After briefly pressing the key once, the scrolling text is started again. After briefly
pressing the key twice, project selection is displayed in the assistant.
N
6.6. Projects
The weQube system provides you with the opportunity of loading projects to the sensor which have been saved
to the SD card, as well as defining start projects.
Projects
Project Management
Current project
Load project
Set start project
Back
Run
Current project: The name of the current project is displayed.
Load project: A stored project included in the project list, or a new project, can
be loaded.
It will be displayed only the first 50 projects, that are stored on
the SD card.
Set start project: One project must be specified as the start-up project. This project
is executed automatically when the sensor is started.
6.6.1. Current Project
Current project
Display of the current project
Project name
The title of the currently loaded project is displayed.
Press the key in order to return to configuration selection in the assistant.
6.6.2. Loading a Project
Load project
Load a project to the sensor which has been stored to the SD card.
Project_1
Project_2
Project_3
Back
Run
Any given project can be selected and loaded to the sensor. The project name ap-
pears in abbreviated form.
To Next Page
Loading...