37
Smart Camera / Vision-Sensor / 1D-/2D-Code-Scanner / OCR Reader
8.2. Firmware Update via FTP-Interface
Connection to the sensor must first be established via an FTP client.
Enter “ftp://” to the address bar in the file explorer followed by the sensor’s IP address to this end, for example:
ftp://192.168.100.1
The following codes have to be entered in order to access the sensor’s micro SD card:
User name: ftpuser
Password
Now copy the downloaded firmware directly to the corresponding location in the file explorer (e.g.
ftp://192.168.100.1/UPDT_weQube_1.1.0.tgz). The new firmware is transferred to the sensor’s micro SD card.
Then restart the sensor via the OLED display (see section 6). The sensor's firmware is updated during the re-
start. Updating takes roughly 10 to 15 minutes.
To Next Page
Loading...