EN
164
Software Module
11.20. Module Numeric Comparison
11.20.1. Overview
Objective
Compare two numbers with each other.
Prerequisites
1. Sensor is correctly connected (see section “5.5. Initial Start-Up” on page 19)
2. Connection has been established from the sensor to the software (see section
“10.1.1. Connecting the Sensor (Connect to Device)” on page 40)
3. The camera is configured / images are selected (see section “11.2. Camera Device
Module” on page 68)
Procedure
First of all, the mathematical operands are specified which will be used to compare the
two numeric values. Fixed values, as well as results, can be used.
11.20.2. Settings
Property
The following settings/results appear.
Process Time [ms] Sensor processing time for the module
Module State Error codes to give support in error diagnosis (see section
“18.5. weQube Software Module States” on page 198)
Output The calculated results are displayed.
Math Function The type of mathematical function is specified:
• A > B
• A < B
• A >= B
• A <= B
• A != B
Input #n Fixed value or variable event from the application
Max. Inputs Specifies the maximum number of inputs. Fixed values or vari-
able results from the application can be assigned to these in-
puts.
To Next Page
Loading...