EN
46
General Layout of weQube Software
10.1.2. Open
After clicking the open icon, a project which has been saved to the PC can be opened. The following
file formats can be selected:
10.1.2.1. Project File
Project files end with .w_p. Sensor settings and a reference image are saved to projects. Projects can be edited
both online and offline. They’re the standard format for application solutions.
10.1.2.2. Teach+ File
Teach+ files end with .w_r. Sensor settings and any desired number of images are saved to Teach+ files. They
can be used for documentation and make it possible to change sensor settings in the offline mode from any-
where in the world. Files which have been edited offline can be uploaded to the sensor as a project file, and the
settings saved to the Teach+ file are then transferred to the sensor.
10.1.2.3. Template Files
Template files end with .w_t. As is also the case with project files, sensor settings and a reference image are
saved to template files, but template files cannot be overwritten simply by means of saving.
Creating Individualized Templates
You can set up your own standards for weQube applications by creating individualized templates. They can be
used, for example, in order to specify that communication for all applications will take place via Profinet, or that
the scanned code always appears at the display.
Templates
Loading Templates for Standard Applications
As a standard feature, several template files are included on the weQube’s micro SD card which cover typical
applications such as checking for presence, distance measurement, 2D code reading, reference image com-
parison and cluster counting.
In order to be able to open these templates and use them as a quick solution for standard applications, con-
nection must first be established with the sensor (see section 10.1.1).
The micro SD card can be accessed directly by clicking the open icon (see section 10.2.3.8). After changing the
file type to *.w_t, all available template files are displayed. After clicking the required template, it’s transferred
to the sensor. With just a few clicks, you can adjust your settings and save the solution for your application as
a project file with the .w_p extension.
The most up-to-date template files can be downloaded from our microsite at www.wenglor.com/weqube. After
establishing a connection with the sensor, you can select the appropriate template file by clicking the open icon
at your PC, and transfer it to the sensor.
To Next Page
Loading...