EN
34
Installing and Updating the Software
7. Installing and Updating the Software
7.1. Minimum Requirements
• Standard Intel Pentium, 2 GHz, 2 GB RAM
• Operating system: MS Windows XP, 7
• 150 MB available hard disk space (Recommended 500 MB)
• Ethernet interface
• Screen resolution 1024 × 960 (Recommended > 1280 × 1024)
7.2. Installation Procedure
First check to see whether or not a more up-to-date version of the software is available from our website.
Additional support for initial start-up a well as further information regarding use of the software can be found on
the microsite at www.wenglor.com/weQube.
If the software on the CD is the latest version, proceed as follows:
1. Insert the installation CD into the CD drive.
2. Run the setup program: “Install_weQube”. Administrator rights are required to this end.
3. Follow the instructions which appear at the screen.
weQube software is installed.
The language setting for the software is the same as for the operating system. If a different language is desired,
it can be selected in the Settings menu.
7.3. Updating the Software
1. Uninstall current weQube software using the Software function in the Control Panel.
2. The latest software version is available from the download area at our website: www.wenglor.com
3. The new software can be installed as described in section 7.2
Before updating the software, make sure that the firmware has been updated to the most recent version. The
current version is always available from the download area at wenglor.com.
To Next Page
Loading...