27
Smart Camera / Vision-Sensor / 1D-/2D-Code-Scanner / OCR Reader
6.5. Assistant
The assistant is started automatically when the sensor is switched on for the first time, and each time the sensor
settings are reset. However, it can also be started manually in order to simplify project selection and sensor
configuration.
Starting the Assistant
The assistant
helps you in
selecting the
most important
settings in ac-
cordance with
your require-
ments. Do you
want to enter
further settings?
Press Y for yes
or N for no,
briefly press
to go back and
press and hold
◄ to exit.
Y
Start the assistant by pressing the “Y” key.
After pressing the “N” key, the assistant is exited and the display is switched to the
full menu.
After briefly pressing the key once, the scrolling text for using the assistant is
started again. The assistant is exited after briefly pressing the key twice, and the
display is switched to the full menu. By pressing and holding the key, the assistant
is exited and the display is switched to the configuration menu.
N
When using the assistant, you’re provided with the following assistance for setting up the sensor:
Loading the configuration from the SD card
Load configura-
tion from SD
card?
Y
If you want to transfer the settings from the SD card to the sensor, press the “Y” key.
Caution: Current sensor settings are overwritten!
If you do not want to overwrite the existing sensor configuration with the settings
saved to the SD card, press the “N” key.
Press the t key in order to return to the initial assistant window.
N
Loading a project from the SD card
Load project
from SD card?
Y
If you want to transfer projects which have been stored to the SD card to the sensor,
press the “Y” key.
Caution: The project which is currently selected at the sensor is overwritten!
If you do not want to select a project which has been saved to the SD card, press
the “N” key.
Press the t key in order to return to configuration selection in the assistant.
N
To Next Page
Loading...